該圖片由注冊用戶"旭派XUPAI"提供，版權聲明反饋
1.電瓶安裝要牢固
電瓶在電動自行車上安裝要牢固，以防騎行時電瓶受振動損害。 電池在搬運中，禁止摔擲、滾翻、重壓。
2.注意保持電瓶干燥、清潔
保持電池的干燥、清潔，防止電瓶自行放電。
3.注意保持電瓶電量充足
絕對不能讓電瓶長期處于電量不足的狀態，并且要養成每天晚上為電瓶充電的良好習慣。長期不用，應該充滿電，放置陰涼干燥處，并定期充電；放電后的蓄電池應及時補充電。
4.注意不能讓電瓶過放電
電動自行車剛起動時，要用腳踏（無腳踏的可以用腳推地面的方式）幫助起動，上坡時候，用腳踏幫助電動車上坡，以免放電電流過大而損壞電瓶。騎行時，要注意不能讓電瓶過放電，蓄電池放電到終止電壓后，繼續放電稱為過放電。過放電容易引起電瓶嚴重虧電，從而大大地縮短其使用壽命。所以蓄電池使用時應盡量避免深度放電，做到淺放勤充。
5.避免過充電
當充電器顯示充滿就停止充電，不能一充電就一夜甚至幾天。過充電會促使極板活性物質硬化脫落，并產生失水和蓄電池變形。蓄電池在高溫季節運行，主要存在過充電的問題。因此，保證良好的散熱，并應遠離熱源。
6.避免長期虧電
在低溫情況下，充電主要存在充電接受能力差、充電不足造成電池虧電的問題，長期虧電會使極板硫化。低溫時應采取保溫防凍措施，特別是充電時應放在溫暖的環境中，有利于保證充足電，防止不可逆硫酸鹽化的產生，延長蓄電池的使用壽命。
7.防止電池安裝短路
在安裝或使用時應特別小心，所用工具應采取絕緣措施，連線時應先將電池以外的電器連好，經檢查無短路，最后連上蓄電池，布線規范應良好絕緣，防止重疊受壓產生破裂。禁止用電池短路的方法來檢測蓄電池的帶電情況，以防止發生爆炸造成人員傷亡。
8.避免蓄電池長時間大電流放電
將極大地損傷電池內部結構。建議車主每次啟動時間不能超過5秒。需要兩次連續啟動，中間要間隔10－15秒的時間。
9.防止在陽光下暴曬
陽光下暴曬會使蓄電池溫度增高，蓄電池各活性物質的活度增加，影響蓄電池使用壽命。
