施工要點

先對施工物表面做防腐處理→充分攪拌均勻防火涂料→施工以刷涂為主，施工第一遍厚度為0.10-0.15mm為宜，表干后進行第二次施工，涂層厚度以0.15-0.20mm為宜，以后各遍施工涂層厚度應控制在0.20mm左右，直至達到規定厚度，每次施工時間間隔以涂層不沾手為準（一般在18-24小時左右）。

驗收注意

涂層當平整，無明顯凹陷，粘結牢固，無粉化、松散和浮漿，乳突已剔除，無漏涂、脫粉、明顯裂縫等。用0.75～1kg榔頭輕擊涂層檢測其強度等，用1m直尺檢測涂層平整度。